Wideye SABRE I Specifications download pdf (Page 17)

For subsequent use, the SABRE™ I will not acquire

a new GPS, it will prompt the user if the previously

stored GPS coordinates should be used.

To use the stored GPS coordinates, use the

Up/Down buttons to select Yes and press ENTER.

A indicator will indicate the use of the stored

GPS coordinates.

To re-acquire a new GPS, select No and press

ENTER. SABRE™ I will repeat Step I to III.

FIGURE 3.4.3-4: LCD display indicating the system’s

query to user if user would like to use the stored

GPS coordinates.

FIGURE 3.4.3-5: LCD display indicating the Signal

Strength Bar

Press the ENTER button and the LCD will show the

signal strength bar.

IV.

3.4.4 Antenna Pointing

SABRE™ I is now in Antenna Pointing state.

To obtain the maximum possible signal strength,

adjust the antenna by turning and tilting it. For

an acceptable service to commence, a signal

strength of minimum 45 dBHz is required. Press

ENTER when the maximum possible signal

strength is obtained.

FIGURE 3.4.4-1: SABRE™ I exhibiting two degrees of

freedom to enable adjustment for optimum signal

strength.

SABRE™ I will start the registration with the network.

FIGURE 3.4.4-2: LCD display indicating that the

SABRE™ I is in the state of Network Registration.

When registration is successful, the service

provider’s name will be displayed.

FIGURE 3.4.4-3: LCD display indicating the “Ready

State” of SABRE™ I. In this state, the terminal is

ready for On Air deployment.

III.

II.

IV.

Location of

Antenna

GPS

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 73 74

No comments

Wideye SABRE I Specifications Page 17